Filter
Top Products
Selecting a Paper Source
Chapter 2: Handling Paper
❖
2-27
Review the following
Source Mapping
examples to take full
advantage of the 4505/4505ps and 4510/4510ps capabilities.
All examples assume that
Default Source
is set to
Standard
.
You do not have a lower base installed. You want to load as
much paper in the printer as possible. You use only one size
of paper. You do not do manual feeding.
1. Load the standard and MP trays with regular paper stock.
2. Set
Source Mapping
for “Standard” to “Standard-MP.”
3. Set
MP Tray Size
to the same size as the regular stock.
4. In either your software application or the Xerox printer
driver, set paper source to the standard tray.
The printer will pull paper from the standard tray until it is
empty, then from the MP tray. When the standard tray is
reloaded, the printer will pull paper from it again.
The Source Mapping setting determines from where the
printer pulls paper.
For the paper sources you intend not to use, always set Source
Mapping to the same setting as that used for your regular
paper stock. You will avoid unexpected results if those paper
sources are used by mistake.
The examples suggest using specific PCL paper sources but
generally you may substitute any source to fit your printing
needs.
Source Mapping
Examples
Example 1
Note
Note
AUG-CH02 Page 27 Black,Red,Cyan Tuesday, March 21, 1995 5:06 PM