Filter
Top Products
PostScript Menu
Chapter 3: Using the Control Panel
❖
3-35
Jam Recovery
Note: The default for Jam
Recovery is
On
for
firmware release 4.0. The
default is
Off
(as shown at
right) for releases > 4.0. To
determine the firmware
release of your printer,
print a Configuration
Sheet.
Off*
On
Determines how the printer recovers from a paper
jam. It is set independently for PCL and PostScript.
When
On
, the printer reprints any pages in the printer
at the time of the jam, after the jam has been cleared.
The printer does this by using a portion of memory to
store data. This setting can reduce printer speed with
minimum memory installed. Printer speed can be
increased by installing additional memory and/or
using the default setting of
Off
.
When
Off
, some pages may be lost after the jam has
been cleared. The print job must be resent, specifying
those pages that did not print as a result of the paper
jam.
See
“Printer Settings that Affect Memory” (page 3-67)
for further information.
Resolution
300x300
600x600*
Dots per inch (dpi).
Some software applications override this setting. If
your software application does not, the printer
assumes the default setting here.
Resolution
can be overridden by software when the
Xerox printer driver is installed.
Higher resolutions require more printer memory. See
“Printer Settings that Affect Memory” (page 3-67)
for
further information.
TrueRes
Off
On*
When
On
, smooths the curves in characters and
graphics to reduce coarseness, thereby improving
image quality.
TrueRes
can be overridden by software when the
Xerox printer driver is installed.
Figure 3.12 PostScript Menu options showing factory settings
(continued)
Option
Setting
Description
AUG-CH03 Page 35 Black,Red,Cyan Friday, February 3, 1995 12:22 AM