Filter
Top Products
PostScript Menu
Chapter 3: Using the Control Panel
❖
3-33
Tray Switching
Note: The default for Tray
Switching is
Standard-MP
or
Low-Std-MP
for
firmware release 4.0. The
default is
Off
(as shown at
right) for releases > 4.0. To
determine the firmware
release of your printer,
print a Configuration
Sheet.
Off*
Standard-MP
MP-Standard
Standard-Lower
†
Lower-Standard
†
Lower-MP
†
Std-Low-MP
†
Low-Std-MP†
MP-Lower
†
MP-Std-Low
†
MP-Low-Std
†
†
Appears only when an
optional lower base is
installed.
Sequence of trays the printer uses when printing a
page of a PostScript print job.
If the tray requested for the page is included in this
sequence, then the whole sequence is used instead of
the requested tray. The first tray used is the one in the
sequence, going from left to right, that satisfies all
page requirements. If the requested tray is not
included in this sequence, then the requested tray
alone is used. For example, if this setting is
“Lower-Standard” and the standard tray (upper) is
requested, then the lower tray will be used first
provided that it contains the requested size of paper.
When this sequence is being used and the current tray
runs out of paper, then the next tray in the sequence
that has the same size paper will be used.
Settings that include the lower tray only appear in the
menu when an optional lower base is installed.
Settings that begin with MP allow for printing of the
first pages of a job on special stock by placing the
required number of sheets of the special stock in the
MP tray.
The factory default is Low-Std-MP when a lower tray
is installed, or Standard-MP when a lower tray is not
installed.
Do not remove either the standard or
lower tray when the printer is feeding
paper.
PostScript drivers other than the Xerox driver may
simply enable or disable
Tray Switching
; they can
not specify a setting.
Figure 3.12 PostScript Menu options showing factory settings
(continued)
Option
Setting
Description
!
Caution
AUG-CH03 Page 33 Black,Red,Cyan Friday, February 3, 1995 12:22 AM