Filter
Top Products
6.2
User Guide
FAXING USING PRESET 2
Faxing Using Preset 2
Your WorkCentre is set up with fax as a factory
default setting for sending Faxes from your PC
modem using the WorkCentre - QuickLink III PC
Fax. This fax software uses the modem on your
PC to send faxes.
You can scan a document for faxing using preset
2.
Place your original face-down on the document
glass or in the Set Document Feeder (M950 only).
On the control panel, press the Scan Mode
button.
Press the right Navigator button until
the display reads, "Scan using: Preset 2."
Press the Select button. A check mark
appears next to preset 2 to show that it is selected.
Press Start and follow the instructions on
the PC screen. The original scans and the
WorkCentre - QuickLink III PC Fax application
opens on your PC with your scanned original
attached.
Note: How to set presets is covered in chapter 4 of
this guide, "Customizing your WorkCentre."
1
2
3
+
-
4
5
00-ugm940.book Page 2 Monday, July 31, 2000 3:20 PM