Filter
Top Products
10 Zebra S-Series User’s Guide
9$&2SHUDWLRQ
1. Confirm that the voltage selector switch is set to 115 V.
2. Attach the supplied power cord to the AC power receptacle located on
the rear of the printer.
3. Connect the opposite end of the power cord to a properly grounded
source of 115 VAC (50 or 60 Hz) power rated for at least 5 Amps.
9$&2SHUDWLRQ
1. Confirm that the voltage selector switch is set to 230 V.
2. Depending on how the printer was ordered, a power cord may or may
not be provided for 230 VAC operation. If not provided, obtain a cord
set with the proper AC power plug. The cord may then be connected
to the standard (international) IEC-type 3-prong AC connector
provided on the S-Series Printer. Refer to “230 VAC Power Cord” on
page 83 for more information.
6LWH5HTXLUHPHQWV
&$87,217RHQVXUHWKDWWKH66HULHV3ULQWHUKDVSURSHU
YHQWLODWLRQDQGFRROLQJGRQRWSODFHDQ\SDGGLQJRUFXVKLRQLQJ
PDWHULDORQWKHEDFNRIRUXQGHUQHDWKWKHXQLWDVWKLVUHVWULFWVWKH
DLUIORZ
The S-Series Printer may be installed on any solid, level surface of
sufficient size and strength to accommodate the unit. The area in which
the printer operates must meet the environmental conditions specified (see
page 77).
Since the Zebra S-Series Printer was designed and is fabricated as an
industrial-type unit, it functions satisfactorily in areas such as a warehouse
or factory floor that conform to the specified environmental and electrical
conditions (see page 76).