Filter
Top Products
Zebra S-Series User’s Guide 51
-ÃlÞlÏÞlÍ"AÏlAYl
2YHUYLHZ
This section contains preventive maintenance information for the Zebra
S-Series Printer. These procedures may be performed by the operator.
&OHDQLQJ
([WHULRU6XUIDFHV
The exterior surfaces of the printer may be cleaned as required by using a
lint-free cloth. Do not use harsh or abrasive cleaning agents or solvents. If
necessary, a mild detergent solution or desktop cleaner may be used
sparingly.
,QWHULRU
Remove any accumulated dirt/lint from the interior of the printer using a
soft bristle brush and/or vacuum cleaner. This area should be inspected
after every four rolls of media.
&OHDQLQJ6FKHGXOH
Table 4
AREA METHOD INTERVAL
Printhead Isopropyl alcohol After every roll of media (or 500
ft. of fanfold media) when
printing direct thermal or after
every roll of ribbon when printing
in thermal transfer mode.
Platen Roller Isopropyl alcohol
Upper and Lower Media
Sensors
Air blow
Media Path Isopropyl alcohol
Ribbon Sensor Air blow
Peel/Tear Bar Isopropyl alcohol As needed.
Label Available Sensor Air blow Monthly.
Cutter Module Isopropyl alcohol and/or air blow As needed.