Zebra Technologies 105SE Printer User Manual


  Open as PDF
of 110
 
8Zebra S-Series User’s Guide
6WRUDJHDQG5HVKLSSLQJ
If you are not placing the printer into operation immediately, repackage it
using the original packing materials. The S-Series Printer may be stored
under the following conditions:
• Temperature: –40° to +158° F (–40° to +70° C)
• Relative humidity: 20% to 85% non-condensing
Should it become necessary to ship your printer, remove any ribbon and
paper roll from the supply spools, otherwise damage to the printer could
result. Carefully pack the printer in a suitable container to avoid damage
during transit. Whenever possible, use the original container and
packaging material from the factory. If you use a different container, a
procedure similar to the original factory packaging should be followed.
&$87,21'RQRWSDFNDJHWKHSULQWHULQDULJLGFRQWDLQHU
ZLWKRXWXWLOL]LQJVKRFNPRXQWVRUVKRFNDEVRUELQJSDFNLQJ
PDWHULDO$ULJLGFRQWDLQHUDOORZVVKRFNRQWKHRXWVLGHWREH
WUDQVPLWWHGXQGDPSHGWRWKHXQLWZKLFKPD\FDXVHGDPDJH
3RZHU&RQQHFWLRQ
$&9ROWDJH6HOHFWLRQ3URFHGXUH
The S-Series Printer’s AC voltage may be set for either 115 VAC or 230
VAC operation. To match the printer’s power entry selection to the
available power source, refer to Figure 1 and follow the procedure outlined
below:
1. Locate the AC power area at the rear of the printer.
2. Using a small flatblade screwdriver or similar tool, move the voltage
selection switch to the 115 V or 230 V position as required. (The
initial position of the switch depends on how the printer was ordered.)
Make sure that the appropriate fuse is in place.
 previous next