80 Zebra S-Series User’s Guide
)DQIROG6XSSO\%LQ
Your printer may be equipped with an optional internal fanfold supply bin.
It is used to load fanfold media within the media compartment, and it
protects the media from environmental contaminants such as dust and dirt.
The fanfold media supply bin is fully adjustable. It accommodates media
from 1.57" (40 mm) to 3.54" (90 mm) wide (7.17" [183 mm] wide for the
160S) and 3.5" (89 mm) to 8" (203mm) long. The maximum stack height
for 8" long media is 4.5". Stack heights of 6.5" may be achieved with
media less than 3.5" long.
The fanfold supply bin may be installed in the field by the operator. To
install the fanfold supply bin, follow the instructions included with the
option.
Note: The fanfold supply bin, peel-off option, and rewind option are
mutually exclusive. The fanfold supply bin may not be installed
in S-Series Printers with the peel-off option or the rewind option.
Fanfold media may be used with the rewind spindle installed by
using one of the external fanfold supply access slots (at the
bottom and rear of the printer).
([WHUQDO=HEUD1HW(WKHUQHW,QWHUIDFH
ZebraNet allows you to connect your printer to your ethernet network.
This interface option is available for both 10Base-2 and 10Base-T
networks.
%ODFN0DUN5HIOHFWLYH6HQVRU
Note: For the 105Se printer only.
The reflective sensor utilizes continuous media with black marks printed
on the back of the label liner. The black mark sensor determines the label
length and the top of the label by detecting the black mark (similar to the
way a transmissive sensor detects the gap or notch).
This option is in addition to the standard transmissive sensor and is
software- or switch-selectable.