Filter
Top Products
Zebra S-Series User’s Guide 27
02'(.H\
The MODE key puts the printer in configuration mode. In this mode, you
can adjust the print darkness, media tear-off position, and label top
position, or perform a calibration. See “Configuration and Calibration”
beginning on page 39 for more information.
)URQW3DQHO/LJKWV
Refer to Figure 11 for the location of the lights.
Note: If an operating condition which causes a light to be ON
constantly and one which causes the same light to flash occur
simultaneously, the light flashes.
Indicator Light Name Status Indication
POWER ON Printer is on.
PRINTHEAD
OFF Normal operation
ON
Head Over Temperature condition. Printing stops until the
printhead cools down. Printing resumes automatically.
Printhead Under Temperature condition. Printing
continues.
Power Supply Over Temperature condition. Printing stops
until the power supply cools down. Printing resumes
automatically.
Flashing Printhead Open.
PAPER/RIBBON
OFF Media and ribbon (if used) are properly loaded.
ON Paper out.
Flashing
1. In Thermal Transfer Mode: Ribbon is out.
2. In Direct Thermal Mode: Ribbon is in the printer.
PAUSE
OFF Normal operation.
ON Printer has stopped all printing operations.
DATA
OFF Normal operation.
ON Labels are printing.
Single Flash The CANCEL key was pressed and a format was
successfully deleted from the print queue.
Flashing Receiving data from host computer.
Slow Flashing Printer sent a “stop transmitting” command to the host
computer.
DARKEN ON
Printer is in the Configuration Mode. See page 42 for
more information.
POSITION ON
CALIBRATE ON