Zebra Technologies 105SE Printer User Manual


 
Zebra S-Series User’s Guide 83
®®lcà
9$&3RZHU&RUG
Depending on how your Zebra S-Series printer was ordered, a power cord
may or may not be included when the printer is optioned for 230 VAC,
50/60 Hz operation.
If a power cord is not supplied, you need to obtain one with the following
specifications:
The overall length must be less than 3.8 meters.
It must be rated for at least 5 amps, 250 V.
The CHASSIS GROUND (EARTH) MUST BE CONNECTED to
assure safety and reduce electromagnetic interference. This is done by
the third wire in the power cord (see Figure 27).
Figure 27
The plug cap should bear the certification mark of a known international
safety organization (see Figure 28).
Figure 28