Filter
Top Products
20 Zebra S-Series User’s Guide
5HPRYLQJ8VHG5LEERQ6
Refer to Figure 10.
1. Turn the knob at the end of the ribbon take-up spindle (1) clockwise
until it stops. This causes the ribbon release bars to pivot down (2),
easing the spindle’s “grip” on the wound ribbon.
2. Slide the ribbon off of the ribbon take-up spindle. Once the used
ribbon has been removed, ensure that the arrow on the knob aligns
with the indented notch in the ribbon take-up spindle (see inset).
3. Remove the empty core from the ribbon supply spindle.
4. Follow the ribbon loading procedure on page 14 to load the new
ribbon.
Figure 10