Filter
Top Products
Troubleshooting
RFID Problems
160
13383L-004 Rev. A XiIIIPlus/R110Xi/R170Xi User Guide 9/6/07
RFID parameters do
not appear in Setup
mode, and RFID
information does not
appear on the printer
configuration label.
The printer was powered
off (
O) and then back on (I) too
quickly for the RFID reader to
initialize properly.
Wait at least 10 seconds after turning the printer
power off before turning it back on.
1. Turn off (
O) the printer.
2. Wait 10 seconds.
3. Turn on (
I) the printer.
4. Check for the RFID parameters in Setup
mode or for RFID information on a new
configuration label.
An incorrect version of printer
or reader firmware was loaded
on the printer.
1.
2. Download the correct printer or reader
firmware if necessary.
3. If the problem persists, contact Technical
Support.
The printer is unable to
communicate with the RFID
reader.
1. Turn off (O) the printer.
2. Wait 10 seconds.
3. Turn on (
I) the printer.
4. If the problem persists, you may have a bad
RFID reader or a loose connection between
the RFID reader and the printer. Contact
Technical Support or an authorized service
technician for assistance.
The printer is RFID-ready, but
no reader is installed.
Contact an authorized Zebra RFID reseller to
acquire a reader for your printer.
Table 17 • RFID Problems (Continued)
Problem Possible Cause Recommended Solution