Filter
Top Products
183
Data Ports
Applicator Interface Connector
9/6/07 XiIIIPlus/R110Xi/R170Xi User Guide 13383L-004 Rev. A
Applicator Interface Connector Pin Configuration
The Applicator Interface Assembly is available in two versions: a +5 V I/O and a
+24–28 V I/O. Table 22 lists the pin configurations and functions of the applicator interface
connector for both +5 V and +24–28 V operation.
Table 22 • Applicator Interface Connector Pin Configuration
Pin
No.
Signal Name Signal Type Description
1 I/O SIGNAL
GROUND
(+5V Return)
I/O Signal
Ground
Using jumper JP2, this pin can be configured as isolated
or non-isolated from the printer signal ground. See
Jumper Configurations and Pinouts for +5 V I/O
Operation on page 186 for more information.
1 I/O SIGNAL
GROUND
(+24-28V Return)
I/O Signal
Ground
No jumpers to configure.
Important • Customer must provide this external
ground. (This ground can come from pin 8 when
operating at 28V for all printers except the
110XiIIIPlus.) See Pinouts for +24-28 V I/O
Operation on page 187 for more information.
2+5V I/O
(Fused at 1 A)
Caution • Replace
the fuse only with
one of the same
type and rating.
Power Using jumper JP1, this pin can be configured as isolated
or non-isolated from the Applicator Interface Circuit
+5 V Supply. See Jumper Configurations and Pinouts for
+5 V I/O Operation on page 186 for more information.
2 +24-28V I/O Power No jumpers to configure. This +24-28V power source
also supplies voltage for output signal pull-up resistors.
Important • Customer must provide this external
power. (This power can come from pin 7 when
operating at 28V for all printers except the
110XiIIIPlus.) See Pinouts for +24-28 V I/O
Operation on page 187 for more information.
3 START PRINT Input See Applicator Signals on page 181 for more information
about the start and end print signals.
• Pulse Mode—The label printing process begins on the
HIGH to LOW transition of this signal if a format is
ready. Deassert this signal HIGH to inhibit printing of
a new label.
• Level Mode—Assert LOW to enable the printer to
print if a label format is ready. When deasserted HIGH,
the printer completes the label that is printing then
stops and waits for this input to be reasserted LOW.
4 FEED Input When the printer is idle or has been paused, assert this
input LOW to trigger repeated feeding of blank labels.
Deassert HIGH to stop feeding blank labels and register
to the top of the next label.
* Applicator boards have separate part numbers for the +5V version (49872-099M) and the +24-28V version (33361-099M).