Filter
Top Products
Configuration
Control Panel Parameters
76
13383L-004 Rev. A XiIIIPlus/R110Xi/R170Xi User Guide 9/6/07
Set Maximum Label Length
This parameter is used during the media portion of the calibration process.
Always set maximum label length to a value that is at least 1.0 in.
(25.4 mm) greater than the actual label length (Figure 17). If the value is set
to a smaller value than the label length, the printer assumes that continuous
media is loaded, and the printer cannot calibrate.
For example, if the label length is 5.0 inches (126 mm) including the
interlabel gap, set the parameter for 6.0 inches (152 mm). If the label length
is 7.5 inches (190 mm), set the parameter for 9.0 inches (229 mm).
Figure 17 • Label Length
Default: 39.0 inches (988 mm).
Range: Values are adjustable in one-inch (25.4 mm) increments.
To change the value shown:
1. Press the right oval to increase the value.
2. Press the left oval to decrease the value.
Table 10 • Printer Parameters (Sheet 5 of 27)
Parameter
Action/Explanation
MAXIMUM LENGTH
39.0IN 988MM
}
2
1
Label length (including interlabel gap)
2
Interlabel gap
3
Set maximum label length to approximately
this value
1
3