Filter
Top Products
75
Configuration
Control Panel Parameters
9/6/07 XiIIIPlus/R110Xi/R170Xi User Guide 13383L-004 Rev. A
Set Print Width
Determines the printable area across the width of the label given the
resolution of the printer.
Default: 104 0/8 MM
Default: depends on specific printer
Note • Setting the width too narrow can result in portions of the
label not being printed on the media. Setting the width too wide
wastes formatting memory and can cause printing off the label and
on the platen roller. This setting can affect the horizontal position of
the label format if the image was inverted using the ^POI ZPL II
command.
To change the value shown:
1. Press the left oval to move the cursor.
2. Press the right oval to increase the value of the digit.
To change the unit of measurement:
1. Press the left oval until the unit of measurement is active.
2. Press the right oval to toggle to a different unit of measure (mm,
inches, or dots).
Table 10 • Printer Parameters (Sheet 4 of 27)
Parameter
Action/Explanation
PRINT WIDTH
- 104 0/8 MM +