Filter
Top Products
37
QL Series User Guide
QL 420/420 Plus Wireless Local Area Network (WLAN) Module
Using PCMCIA Radio
The following section only applies when the PCMCIA WLAN module (FCC ID: I28-
QL420352) is installed in the QL 420 or QL 420 Plus printer. (Note that only one of the
radio options can be installed in the printer at one time). The antenna used for this
transmitter must not be co-located or must not operate in conjunction with any other
antenna.
The FCC ID number label is on the front of the module for the QL 420 and on the back
label of the QL 420 Plus. On all models the text can be read with the module in-
stalled.
WARNING: Use of the QL 420 or QL 420 Plus with the radio
module marked with “FCC ID: I28-QL420352” meets the FCC
requirements for radio frequency (RF) radiation exposure in the
standard body worn configuration with no minimum separation. In
this configuration, which applies whether the belt clip or shoulder
strap is used, the face of the printer from which paper is
transported is facing away from the user’s body. The standard
configuration must always be used when the printer is body worn.
This configuration maintains the required 1 cm separation
distance.
The printer with this radio option has been SAR tested. The
maximum SAR value measured was 1.04. W/kg averaged over 1
gram.
European Regulatory Information for this Radio
AT BE CY CZ DK
EE FI FR DE GR
HU IE IT LV LT
LU MT NL PL PT
SK SI ES SE GB
Note: -Member states in the EU with restrictive use for this device are crossed
out!
This device is also authorized for use in all EFTA member states (CH, ICE, LI,
NOR)
0336
Important Notice:
This device is a portable RF printer intended for com-
mercial and industrial use in all EU and EFTA mem-
ber states except in France where restrictive use ap-
plies.
continued