Filter
Top Products
3. Turn the power switch ON. When the Power ON Self Test is complete, the
POWER and PAUSE lights will be ON and the PRINTHEAD light will FLASH.
4. Press the MODE key 3 times briefly. PAUSE and CALIBRATE lights turn ON.
5. Close the Head Open Lever.
6. Press UP to calibrate. The printer feeds some media. The MODE lights will flash
ON and OFF to indicate that the settings have been saved in memory.
7. Press PAUSE to exit the PAUSE mode. The PAUSE light turns OFF.
Adjust the Print Darkness
This procedure sets the darkness of the printing on the label. To maximize the life of the
printhead, use the lowest setting which provides the necessary print quality.
1. Press the MODE key. PAUSE and DARKEN lights turn ON.
2. Press UP or DOWN to adjust the current setting.
3. Press the MODE key 3 times briefly. The MODE lights will flash ON and OFF to
indicate that the settings have been saved in memory.
4. Press PAUSE to exit the PAUSE mode. The PAUSE light turns OFF.
Adjust the Media Rest Position
This procedure sets the end-of-label position relative to the Tear-Off Plate or Cutter.
Adjust this if your label is not being torn or cut at the correct point.
1. Press the MODE key twice briefly. PAUSE and POSITION lights turn ON.
2. Press UP or DOWN to adjust the current setting.
3. Press the MODE key twice briefly. The MODE lights will flash ON and OFF to
indicate that the settings have been saved in memory.
4. Press PAUSE to exit the PAUSE mode. The PAUSE light turns OFF.
Adjust the Position of the Top of the Label
This procedure positions the printing on the label relative to the top edge of the label.
Adjust this if your printing is too close or too far away from the top or bottom edge of
the label.
1. Press the MODE Key twice briefly then press and hold it for about 5 seconds until
the lights change. The PAUSE, DARKEN, and CALIBRATE lights turn ON.
2. Press UP or DOWN to adjust the current setting.
3. Press the MODE key twice briefly. The MODE lights will flash ON and OFF to
indicate that the settings have been saved in memory.
4. Press PAUSE to exit the PAUSE mode. The PAUSE light turns OFF.
1
Getting Started
15