Filter
Top Products
IV. Reassemble the Cutter Module.
1. See Figure 22. Position the two Wire Springs down against the Lower Cutter Blade.
2. Place the Rear Cutter Blade Guard over the Wire Springs, perpendicular to its final position.
Place your thumbs on the top (flat) part of the Guard.
NOTE:
Insure that the ends of the Rear Cutter Blade Guard are positioned on the outside of
the Cutter Side Panels.
3. See Figure 22. Press the Rear Cutter Blade Guard down and forward, rotating the Guard as
you proceed, to lock the mounting pins into position in the Cutter Side Panel mounting slots.
Slide the Guard forward until the two Wire Spring Loops pop up on the back side of the Guard.
NOTE:
Insure that the Wire Springs remain positioned under the Rear Cutter Blade Guard
when assembly is completed.
4. Lower the Upper Cutter Blade Guard back to its normal position. When reassembled, the back
of the Cutter Module should look like the one shown in Figure 23.
This procedure is continued on page 32.
Figure 21 Cutter Module Reassembly
Figure 22 Side View of Cutter Module Reassembly
Routine Care and Adjustment
30