Filter
Top Products
Operations
Load Media in Tear-Off Mode
42
13290L-004 Rev. A S4M User Guide 6/15/09
Load Media in Tear-Off Mode
Figure 9 shows roll and fanfold media loaded in Tear-Off mode, which is the default print
mode.
Figure 9 • Tear-Off Mode
To load media in Tear-Off Mode, complete these steps:
1. Set the printer to Tear-Off mode. See Select the Label Removal Method on page 74 for
instructions.
2. Insert media into the printer. See Insert Media into the Printer on page 40 for instructions.
Roll Media
Fanfold Media
1
Printhead assembly
5
Dancer
2
Transmissive sensor
6
Media guide
3
Media supply guide
7
Printhead release latch
4
Media supply hanger
8
Printed label
Caution • While performing any tasks near an open printhead, remove all rings, watches,
hanging necklaces, identification badges, or other metallic objects that could touch the
printhead. You are not required to turn off the printer power when working near an open
printhead, but Zebra recommends it as a precaution. If you turn off the power, you will lose
all temporary settings, such as label formats, and you must reload them before you resume
printing.
1
2
5678
4
3
1
2
5678
4
3