Filter
Top Products
75
Configuration
Control Panel Parameters
6/15/09 S4M User Guide 13290L-004 Rev. A
PRINT SPEED
Adjust Print Speed
Adjusts the speed for printing a label (given in whole numbers of inches
per second). Slower print speeds typically yield better print quality. Print
speed changes take effect upon exiting Setup mode.
Range: 2 to 6 IPS
Default Value (ZPL, APL-I): 2 IPS
Default Value (EPL, APL-D): 6 IPS
To modify this parameter:
• To increase the value, press the up arrow.
• To decrease the value, press the down arrow.
PRINT WIDTH
Set Print Width
Print width determines the printable area across the width of the label.
Important • Setting the width too narrow can result in portions of
the label not being printed on the media. Setting the width too wide
wastes formatting memory and can cause printing off the label and
on the platen roller. This setting can affect the horizontal position
of the label format if the image was inverted using the ^POI
ZPL II command.
Range: 2 to 832 for 8 dots/mm, 2 to 1248 for 12 dots/mm
Default Value: 832 for 8 dots/mm, 1248 for 12 dots/mm
To modify this parameter:
• To increase the value, press the up arrow.
• To decrease the value, press the down arrow.
KDU MODE
(EPL mode only)
Enable KDU
Allows the S4M printer to work with a Keyboard Display Unit (Zebra
KDU or KDU Plus™).
Selections: ON, OFF
Default Value: OFF
To modify this parameter:
• Press the up or down arrow to scroll through the selections.
COMPAT. MODE
(APL-D mode only)
Set APL-D Compatibility Mode
Sets compatibility with some older DPL printers. The default label top
changes from 1.1 inches to 2.5 inches.
Selections: ON, OFF
Default Value: OFF
To modify this parameter:
• Press the up or down arrow to scroll through the selections.
Table 14 • Printer Parameters, Password Levels 1 and 2 (Page 4 of 5)
Parameter Explanation