Filter
Top Products
Configuration
Control Panel Parameters
74
13290L-004 Rev. A S4M User Guide 6/15/09
MEDIA TYPE
Set Media Type
Tells the printer which type of media you are using.
Selections:
• GAP/NOTCH—Use for non-continuous web media, non-continuous
fanfold media, and tag stock.
• CONTINUOUS—Use for media that does not have divisions
between labels.
• MARK—Use for non-continuous black mark media.
Default Value: GAP/NOTCH
To modify this parameter:
• Press the up or down arrow to scroll through the selections.
SENSOR SELECT
Select the Media Sensor
Use the setting that gives the best results. You can use the reflective sensor
for most media.
• REFLECTIVE—Use with black mark media and most other media
types.
• TRANSMISSIVE—Use with any media (other than black mark
media) that does not work well with the reflective sensor.
To use the transmissive sensor with media that has holes or notches,
verify that the holes or notches pass through the sensor so that the
sensor can detect them. If the holes or notches do not pass through
the sensor, use the reflective sensor.
Default Value: REFLECTIVE
To modify this parameter:
• Press the up or down arrow to scroll through the selections.
REMOVAL
Select the Label Removal Method
The label removal must correspond to the print mode (see Print Modes
and Printer Options on page 38). Be sure to select a label removal mode
that your hardware configuration supports because some of the selections
displayed are for optional printer features.
Selections: TEAR, PEEL, CUTTER, REWIND, DELAYED CUT
Default Value: TEAR
To modify this parameter:
• Press the up or down arrow to scroll through the selections.
Table 14 • Printer Parameters, Password Levels 1 and 2 (Page 3 of 5)
Parameter Explanation