Filter
Top Products
73
Configuration
Control Panel Parameters
6/15/09 S4M User Guide 13290L-004 Rev. A
TEAR OFF
Adjust Tear-Off Position
This parameter establishes the position of the labels over the
tear-off/peel-off bar after printing.
Note • The printer applies and saves the tear-off setting
immediately. Exiting Setup mode without saving changes does not
restore the previous value.
Range (ZPL, EPL, APL-I): -120 to +120
Default Value (ZPL, EPL, APL-I): 0
Range (APL-D): +00i to +999i (0m to 2537m)
Default Value (APL-D): +128i
To modify this parameter:
• Press the up arrow to increase value.
• Press the down arrow to decrease value.
LABEL TOP
(ZPL, EPL, and APL-D
modes)
X FORMS ADJUST
(APL-I mode only)
Adjust Label Top Position
The label top position adjusts the print position vertically on the label.
Positive numbers adjust the label top position farther down the label (away
from the printhead), and negative numbers adjust the position up the label
(toward the printhead).
Range (ZPL, EPL): -120 to +120
Range (APL-I): -10 to +4000
Range (APL-D): -0.64i to 0.64i
Default Value: 0
To modify this parameter:
• To increase the value, press the up arrow.
• To decrease the value, press the down arrow.
LEFT POSITION
(ZPL, EPL, and APL-D
modes)
Y FORMS ADJUST
(APL-I mode only)
Adjust Label Left Position
The label left position adjusts the print position horizontally on the label.
Positive numbers move the left edge of the image toward the center of the
label while negative numbers shift the left edge of the image toward the
left edge of the label.
Range (ZPL, EPL, APL-D): -120 to +120
Range (APL-I): -9999 to +9999
Default Value: 0
To modify this parameter:
• To increase the value, press the up arrow.
• To decrease the value, press the down arrow.
Table 14 • Printer Parameters, Password Levels 1 and 2 (Page 2 of 5)
Parameter Explanation