Filter
Top Products
Configuration
Control Panel Parameters
82
13290L-004 Rev. A S4M User Guide 6/15/09
CHANGE RTC TIME
Set RTC (Real-time clock) Time
If RTC is installed, this parameter allows you to set the RTC time.
Note • The printer saves the RTC time immediately.
To modify this parameter:
1. Press ENTER.
The printer displays the current RTC time.
2. Modify the values as follows:
• Press the right arrow to move to the next digit position.
• To increase the value, press the up arrow.
• To decrease the value, press the down arrow.
3. Press ENTER to accept the value shown.
LOAD DEFAULTS
Load Factory Defaults
Sets all parameters back to factory defaults.
Important • Use care when using this command. All printer
parameters are reset to factory values with this command. If
possible, print a configuration label to have as a record of the
printer’s settings before loading defaults.
How to select this parameter:
1. Press ENTER.
The printer asks
ARE YOU SURE?
2. To load factory defaults, press ENTER to select YES. To cancel, press
any other key.
DEFAULT NET
Reset Network Parameters
Resets the network parameters back to the factory defaults.
1. Press ENTER.
The printer asks
ARE YOU SURE?
2. To reset network parameters to the factory defaults, press ENTER to
select
YES. To cancel, press any other key.
INIT FLASH MEM
Initialize Flash Memory
This parameter allows you to erase the printer’s Flash memory.
Important • The internal Flash memory is entirely erased with this
command.
To select this parameter:
1. Press ENTER to select YES.
The printer asks
ARE YOU SURE?
2. To initialize Flash memory, press ENTER. To cancel, press any other
key.
Table 15 • Printer Parameters, Password Level 3 (Page 6 of 10)
Parameter Explanation