Filter
Top Products
28 Zebra Z4M/Z6M Printers User’s Guide
3RZHU3HHO5HZLQG3HHO0RGH
(Power peel/rewind option required)
Refer to Figure 18.
1. Press the printhead open lever. The printhead assembly springs up.
2. Flip down the media supply guide.
3. Slide out the media guide as far from the printer frame as possible.
4. Place the roll of media on the media supply hanger and orient the media properly.
5. Flip up the media supply guide.
6. Slide in the media supply guide so that it just touches, but does not restrict, the
edge of the roll.
7. Feed the media under the dancer, through the slot in the transmissive sensor, and
under the ribbon sensor.
8. Pull approximately 36" (915 mm) of media through the front of the printer.
9. Remove the labels from the first 18" of media so that only the liner remains.
10.Ensure that the media is against the back of the transmissive sensor. Slide in the
media guide so that it just touches, but does not restrict, the edge of the media.
11.Pull down the value peel lever to open the value peel assembly.
12.Feed the media over the tear-off/peel-off bar, and through the slot in the value peel
assembly.
13.Loosen the thumbscrew and slide out the rewind media guide to the end of the
take-up spindle.
14.Slide an empty core onto the take-up spindle; wrap the liner around the core and
turn the take-up spindle counterclockwise to wind up the excess liner material.
NOTE: The liner must be attached to the take-up spindle for the printer to
operate properly. Make sure the edge of the liner is flush against the backplate
of the take-up spindle (see “Rewind Media Alignment” on page 67 for details).
15.Slide the rewind media guide against the liner material and tighten the thumbscrew
to lock it into position.