Filter
Top Products
24 Zebra Z4M/Z6M Printers User’s Guide
9DOXH3HHORII0RGH
(Value peel-off option required)
Refer to Figure 16.
1. Press the printhead open lever. The printhead assembly springs up.
2. Flip down the media supply guide.
3. Slide out the media guide as far from the printer frame as possible.
4. Place the roll of media on the media supply hanger and orient the media properly.
5. Flip up the media supply guide.
6. Slide in the media supply guide so that it just touches, but does not restrict, the
edge of the roll.
7. Feed the media under the dancer, through the slot in the transmissive sensor, under
the ribbon sensor, and through the cutter module.
8. Pull approximately 12" (305 mm) of media through the front of the printer.
9. Ensure that the media is against the back of the transmissive sensor. Slide in the
media guide so that it just touches, but does not restrict, the edge of the media.
10.Pull down the value peel lever to open the value peel assembly.
11.Feed the liner over the tear-off/peel-off bar and behind the value peel assembly.
12.Close the printhead assembly.
13.Close the value peel assembly using the value peel lever.
14.If the printer is paused (the PAUSE light is on), press the PAUSE key to enable
printing.
Peeling starts automatically. Press the FEED key to test.