Filter
Top Products
Zebra Z4M/Z6M Printers User’s Guide 71
:DUQLQJ³&877(5-$0
2872)0(025<
3ULQW4XDOLW\3UREOHPV
*HQHUDOSULQWTXDOLW\LVVXHV
Problem Solution
Cutter blade is in the media path.
Turn off the printer power and unplug the printer. Inspect
the cutter module for debris and clean as needed following
the cleaning instructions on page 64.
Problem Solution
*There is not enough memory to perform the
function shown on the second line of the error
message.
Insufficient DRAM for the label length, downloaded fonts/
graphics, and images.
Ensure that the device, such as FLASH memory or
PCMCIA card, is installed and not write protected or full.
Ensure that the data is not directed to a device that is not
installed or available.
Problem Solution
You are using an incorrect media and ribbon
combination for your application.
Consult your authorized Zebra reseller/distributor for
information and advice.
The printer is set at an excessive print speed
to achieve optimal quality.
For optimal print quality, set the print speed to a lower
setting via ZPL II, the driver, or the software.
The printer is set at an excessive darkness
level to achieve optimal quality.
For optimal print quality, set the darkness level to a lower
setting via the front panel, the driver, or the software.
The printhead is dirty. Clean the printhead according to the instructions on
page 56.
There is light printing (or no printing) on the
left or right side of the label or the printed
image is not sharp.
The pressure adjustment dials need to be adjusted. Follow
the printhead pressure adjustment instructions on page 65.