Filter
Top Products
38 Zebra Z4M/Z6M Printers User’s Guide
&KDQJLQJ3DVVZRUG3URWHFWHG3DUDPHWHUV
Certain parameters are password protected by factory default.
NOTE: You have the option of making all parameters password protected.
See “PASSWORD LEVEL” on page 52 for details.
CAUTION: Do not change password-protected parameters unless you are
sure you know what you are doing! If set incorrectly, these parameters
could cause the printer to function in an unpredictable way.
The first attempt to change a password-protected parameter requires you to enter a
four-digit password at the “ENTER PASSWORD” display. The DECREMENT (–)
key changes the selected digit position. The INCREMENT (+) key increases the
selected digit value. After entering the password, press the SELECT key. The
parameter you wish to change is displayed. If the password was entered correctly, you
can now change the value.
The default password value is 1234. The password can be changed using the ^KP
(Define Password) ZPL II instruction.
NOTE: Once the password has been entered correctly, it does not have to be
entered again unless you leave and re-enter the programming mode using the
SETUP/EXIT key.
NOTE: You can disable the password protection feature so that it no longer
prompts you for a password by setting the password to ØØØØ via the ^KPØ
ZPL/ZPL II command. To re-enable the password-protection feature, send the
ZPL/ZPL II command ^KPx, where “x” can be any number that is one to four
digits in length, except Ø.