Filter
Top Products
14 Zebra Z4M/Z6M Printers User’s Guide
&RQILJXULQJWKH3ULQWHU
The configuration procedure in Table 1 contains the information you need to get your
printer up and running, but it is not comprehensive. Refer to page 37 for more
information.
1. Press the SETUP/EXIT key at the “PRINTER READY” display to enter the
configuration mode.
NOTE: You need to press the INCREMENT (+) key more than once to
advance to some of the displays.
2. Press the INCREMENT (+) or DECREMENT (–) key to scroll to the setting you
wish to change.
3. Press the SELECT key to toggle the functionality of the INCREMENT (+) and
DECREMENT (–) keys.
4. Press the INCREMENT (+) or DECREMENT (–) keys to increase or decrease the
value; answer “yes” or “no”; print a label; or select the digit you wish to change.
5. Press the SELECT key again to use the INCREMENT (+) and DECREMENT (–)
keys to scroll to the desired menu item.
6. After you have configured the print method, press the SETUP/EXIT key to save
the changes and exit the configuration mode.
Table 1
Parameter Selections/Explanation
PRINTER READY You are ready to configure the printer
DARKNESS 0 to 30 (default setting is “10”)
PRINT MODE Tear-off, peel-off, liner take-up, cutter, rewind (default setting is tear-off)
MEDIA TYPE Non-continuous, continuous (default setting is “non-continuous”)
SENSOR TYPE Web, mark (default setting is “web”)
PRINT METHOD Thermal transfer, direct thermal (default setting is “thermal transfer”)