Filter
Top Products
Zebra Z4M/Z6M Printers User’s Guide 53
* ZebraNet
®
PrintServer II option required
Display Shows Action/Explanation
IP RESOLUTION*
IP Resolution: Press the INCREMENT (+) or DECREMENT (–) key to display
other choices.
Default: Dynamic
Selections: Dynamic, permanent
Depending on the selection, allows either the user (”permanent”) or the server
(”dynamic”) to select the IP address. For more information, refer to ZebraNet
Networking: PrintServer II Installation and User’s Guide.
IP PROTOCOLS*
IP Protocols: Press the INCREMENT (+) or DECREMENT (–) key to display other
choices.
Default: All
Selections: All, gleaning only, RARP, BOOTP, DHCP, DHCP/BOOTP
If “dynamic” was chosen in the previous parameter, this selection determines the
method(s) by which the PrintServer II receives the IP address from the server. For
more information, refer to ZebraNet Networking: PrintServer II Installation and
User’s Guide.
IP ADDRESS*
IP Address: Press the DECREMENT (–) key to move to the next digit position,
press the INCREMENT (+) key to increase the value of the digit.
This parameter allows you to select the IP address if “permanent” was chosen in “IP
RESOLUTION.” (If “dynamic” was chosen, the user cannot select the address.)
For more information, refer to ZebraNet Networking: PrintServer II Installation and
User’s Guide.
SUBNET MASK*
Subnet Mask: Press the INCREMENT (+) or DECREMENT (–) key to display
other choices.
Default: Permanent (user must set)
Selections: Dynamic (user may set, but server can assign), permanent
This parameter selects the part of the IP address that is considered to be part of the
local network. It can be reached without going through the default gateway.
DEFAULT
GATEWAY*
Default Gateway: Press the DECREMENT (–) key to move to the next digit
position, press the INCREMENT (+) key to increase the value of the digit.
This parameter allows you to select the IP address that the network traffic is routed
through if the destination address is not part of the local network.