Filter
Top Products
9
3
33
3 If the Encapsulation setting that you entered starts with
either PPPoE or PPPoA: Click Write Settings to Flash and
Reboot and Confirm. Once the process is complete, the
X5v’s LINK light should remain on steady (this should take
about 15 seconds). If it doesn’t, go to the Troubleshooting
Tips on page 12.
If the Encapsulation setting that you entered starts with
either 1483 Bridged or 1483 Routed: You must check now to
make sure that your IP Addressing is correctly set. See Setting
IP Addressing on page 11.
4
44
4 Go to your Web browser (i.e., Internet Explorer or Netscape
Navigator) and try to connect to a familiar Web address.
5
55
5 If you connect successfully, your installation is complete
and you’re ready to browse the web! Continue with Step 5:
Setting Up VoIP Service on page 13.
If you do not connect successfully, refer to the
Troubleshooting Tips on page 12.
If You Do Not Have VPI, VCI, and
Encapsulation Settings from Your
DSL Service Provider
If you do not have the settings from your service provider, the
tables beginning on page 30 show the settings for the most
commonly encountered service providers in the USA and many
other countries. If there is more than one setting for your service
provider, the most common is labeled (1), the next (2), and so on.
1
11
1 Go to the Tables on page 30 and find your service provider
on the list. If you are in the USA and your service provider is
not on the list, follow the instructions using the settings for
Service Provider Not Shown at the bottom of the table.
2
22
2 Now enter the corresponding VPI, VCI, and
Encapsulation settings in the appropriate boxes in the Basic
Setup menu. The screen may change slightly, depending on