Filter
Top Products
Prestige 660H/HW Series User’s Guide
247 Chapter 25 Internet Access
Figure 136 Menu 1 General Setup
Menu 1 - General Setup
System Name= ?
Location= location
Contact Person's Name=
Domain Name=
Edit Dynamic DNS= No
Route IP= Yes
Bridge= No
Press ENTER to Confirm or ESC to Cancel:
25.6 Internet Access Configuration
Menu 4 allows you to enter the Internet Access information in one screen. Menu 4 is actually
a simplified setup for one of the remote nodes that you can access in menu 11. Before you
configure your Prestige for Internet access, you need to collect your Internet account
information.
Use the Internet Account Information table in the Quick Start Guide to record your. Note that
if you are using PPPoA or PPPoE encapsulation, then the only ISP information you need is a
login name and password. You only need to know the Ethernet Encapsulation Gateway IP
address if you are using ENET ENCAP encapsulation.
From the main menu, type 4 to display Menu 4 - Internet Access Setup, as shown next.
Figure 137 Menu 4 Internet Access Setup
Menu 4 - Internet Access Setup
ISP's Name= MyISP
Encapsulation= RFC 1483
Multiplexing= LLC-based
VPI #= 8
VCI #= 35
ATM QoS Type= CBR
Peak Cell Rate (PCR)= 0
Sustain Cell Rate (SCR)= 0
Maximum Burst Size (MBS)= 0
My Login= N/A
My Password= N/A
ENET ENCAP Gateway= N/A
IP Address Assignment= Static
IP Address= 0.0.0.0
Network Address Translation= SUA Only
Address Mapping Set= N/A
Press ENTER to Confirm or ESC to Cancel:
The following table contains instructions on how to configure your Prestige for Internet access