Filter
Top Products
Prestige 660H/HW Series User’s Guide
Chapter 26 Remote Node Configuration 250
CHAPTER 26
Remote Node Configuration
This chapter covers remote node configuration.
26.1 Remote Node Setup Overview
This section describes the protocol-independent parameters for a remote node. A remote node
is required for placing calls to a remote gateway. A remote node represents both the remote
gateway and the network behind it across a WAN connection. When you use menu 4 to set up
Internet access, you are configuring one of the remote nodes.
You first choose a remote node in Menu 11- Remote Node Setup. You can then edit that
node’s profile in menu 11.1, as well as configure specific settings in three submenus: edit IP
and bridge options in menu 11.3; edit ATM options in menu 11.6; and edit filter sets in menu
11.5.
26.2 Remote Node Setup
This section describes the protocol-independent parameters for a remote node.
26.2.1 Remote Node Profile
To configure a remote node, follow these steps:
1 From the main menu, enter 11 to display Menu 11 - Remote Node Setup.
2 When menu 11 appears, as shown in the following figure, type the number of the remote
node that you want to configure.