Filter
Top Products
Prestige 660H/HW Series User’s Guide
253 Chapter 26 Remote Node Configuration
26.2.3 Outgoing Authentication Protocol
For obvious reasons, you should employ the strongest authentication protocol possible.
However, some vendors’ implementation includes specific authentication protocol in the user
profile. It will disconnect if the negotiated protocol is different from that in the user profile,
even when the negotiated protocol is stronger than specified. If the peer disconnects right after
a successful authentication, make sure that you specify the correct authentication protocol
when connecting to such an implementation.
PAP – accept PAP (Password Authentication Protocol) only.
Route This field determines the protocol used in routing. Options are IP and None.
Bridge When bridging is enabled, your Prestige will forward any packet that it does not
route to this remote node; otherwise, the packets are discarded. Select Yes to
enable and No to disable.
Edit IP/Bridge Press [SPACE BAR] to select Yes and press [ENTER] to display Menu 11.3 –
Remote Node Network Layer Options.
Edit ATM Options Press [SPACE BAR] to select Yes and press [ENTER] to display Menu 11.6 –
Remote Node ATM Layer Options.
Edit Advance
Options
This field is only available when you select PPPoE in the Encapsulation field.
Press [SPACE BAR] to select Yes and press [ENTER] to display Menu 11.8 –
Advance Setup Options.
Telco Option
Allocated Budget
(min)
This sets a ceiling for outgoing call time for this remote node. The default for this
field is 0 meaning no budget control.
Period (hr) This field is the time period that the budget should be reset. For example, if we
are allowed to call this remote node for a maximum of 10 minutes every hour,
then the Allocated Budget is (10 minutes) and the Period (hr) is 1 (hour).
Schedule Sets This field is only applicable for PPPoE and PPPoA encapsulation. You can apply
up to four schedule sets here. For more details please refer to
Chapter 39 on
page 352.
Nailed up
Connection
This field is only applicable for PPPoE and PPPoA encapsulation. This field
specifies if you want to make the connection to this remote node a nailed-up
connection. More details are given earlier in this section.
Session Options
Edit Filter Sets Use [SPACE BAR] to choose Yes and press [ENTER] to open menu 11.5 to edit
the filter sets. See
Section 26.4 on page 256 for more details.
Idle Timeout (sec) Type the number of seconds (0-9999) that can elapse when the Prestige is idle
(there is no traffic going to the remote node), before the Prestige automatically
disconnects the remote node. 0 means that the session will not timeout.
When you have completed this menu, press [ENTER] at the prompt “Press ENTER to Confirm
or ESC to Cancel:
” to save your configuration, or press [ESC] at any time to cancel.
Table 84 Menu 11.1 Remote Node Profile (continued)
FIELD DESCRIPTION