Filter
Top Products
ES-2024 Series User’s Guide
Chapter 32 Configuration Mode Commands 222
Syntax:
igmp-filtering
igmp-filtering profile <name> start-address <ip> end-address <ip>
where
An example is shown next.
• Enable IGMP filtering on the switch.
• Create an IGMP filtering profile filter1 and specify the multicast IP addresses in the
range
224.255.255.0 to 225.255.255.255 to belong to this profile.
32.4 Enabling STP
Use the spanning-tree or commands to enable and configure STP on the switch.
Syntax:
spanning-tree
spanning-tree priority <0-61440>
spanning-tree hello-time <1-10> maximum-age <6-40> forward-delay <4-30>
spanning-tree <port-list> path-cost <1-65535>
spanning-tree <port-list> priority <0-255>
igmp filtering
= Enables IGMP filtering on the switch
profile <name> =
Specifies a name (up to 32 alphanumeric characters) for this IGMP
profile. If you want to edit an existing IGMP profile enter the existing
profile name followed by
start-address and end-address
parameters.
start-address
<ip>
=
Specifies the starting multicast IP address for a range of multicast IP
addresses that you want to belong to the IGMP filter profile. IP
address in the range 224.0.0.0 to 239.255.255.255 are used for IP
multicasting.
end-address
<ip>
=
Specifies the ending multicast IP address for a range of multicast IP
addresses that you want to belong to the IGMP filter profile. IP
address in the range 224.0.0.0 to 239.255.255.255 are used for IP
multicasting.
sysname(config)# igmp-filtering
sysname(config)# igmp-filtering profile filter1 start-address 224.255.255.0
end-address 225.255.255.255