Filter
Top Products
ES-2024 Series User’s Guide
Chapter 32 Configuration Mode Commands 224
• Set the priority for port 10 to 20.
32.5 no Command Examples
These are the commonly used command examples that belong to the no group of commands.
The
no group commands are commands which are preceded by keyword no. This command
negates the intended action of the command. In most cases the
no command disables, resets or
clears settings. There are cases, however, where the
no command can activate features. This
section shows some uses of these commands.
32.5.1 Disable Commands
Use the no command to disable features on the switch.
Syntax:
no spanning-tree
This command disables STP on the switch.
32.5.2 Resetting Commands
Use the no command to reset switch settings to their default values.
Syntax:
no https timeout
This command resets the HTTPS session timeout to the default.
An example is shown next. The session timeout is reset to 300 seconds.
32.5.3 Re-enabling Commands
The no command can also be used to re-enable features which have been disabled.
sysname(config)# spanning-tree
sysname(config)# spanning-tree priority 0
sysname(config)# spanning-tree hello-time 4 maximum-age 20 forward-delay 15
sysname(config)# spanning-tree 10 path-cost 150
sysname(config)# spanning-tree 10 priority 20
sysname(config)# no https timeout
Cache timeout 300