Filter
Top Products
Dimension ES-3124 Ethernet Switch
29-6 Command Examples
29.4.4 ip dhcp Commands
Syntax:
ip dhcp swif0 mode none (This command disables DHCP on the switch interface (swif0))
ip dhcp swif0 status (This command displays the DHCP status on the switch interface
(swif0))
An example is shown next.
Figure 29-11 ip dhcp Command Examples
29.5 Enabling rstp on the Stacking Ports
Step 1. First enable RSTP
sys sw rstp bridge enable
Step 2. Then enable RSTP on the stacking port.
sys sw rstp port enable 25
sys sw rstp port enable 26
Step 3. Save the configuration
config save
test_mem> ip dhcp swif0 mode none
test_mem> ip dhcp swif0 status
DHCP on iface swif0 is none