Filter
Top Products
Dimension ES-3124 Ethernet Switch
30-2 IEEE 802.1Q Tagged VLAN
The following procedure shows you how to configure tagged VLAN.
Step 1. Use the IEEE 802.1Q tagged VLAN commands to configure tagged VLAN for the switch.
• Use the
sys sw vlan1q svlan setentry command to configure a VLAN ID for each port on the
switch.
• Use the
sys sw vlan1q svlan active command when you are finished configuring the VLAN (see
the last step).
• Use the
sys sw vlan1q port defaultVID command to set the VLAN ID you created for a port to
that specific port in the PVID table.
• Use the
sys sw vlan1q svlan active command to activate the VLAN IDs.
Example:
Figure 30-1 Tagged VLAN Configuration and Activation Example
Step 2. Configure your management VLAN.
• Use the
sys sw vlan1q svlan setentry command to configure a VLAN ID (VID 3 in this example)
for managing the switch (the “management” or “CPU” VLAN).
• Use the
sys sw vlan1q svlan active command to activate the new management VLAN ID.
Example:
Figure 30-2 CPU VLAN Configuration and Activation Example
Step 3. Perform the procedure below to complete the VLAN setup.
a. Telnet to the operational IP address of the switch.
b. Use the
sys sw vlan1q svlan cpu command to set VID 3 as the management VLAN.
c. Use the
sys sw svlan delentry command to remove the default VLAN ID (1).
Example:
ES-3124> sys sw vlan1q svlan setentry example 3 24 fixed tag
ES-3124> sys sw vlan1q svlan active 3
ES-3124> sys sw vlan1q svlan setentry up1 2000 24 fixed tag
for newly create VLAN, please use svlan active <VID> to activate this entry
ES-3124> sys sw vlan1q port defaultVID 24 2000
ES-3124> sys sw vlan1q svlan setentry up1 2001 25 fixed untag
for newly create VLAN, please use svlan active <VID> to activate this entry
ES-3124> sys sw vlan1q port defaultVID 25 2001
ES-3124> sys sw vlan1q svlan active 2000
ES-3124> sys sw vlan1q svlan active 2001