Filter
Top Products
ZyAIR Wireless Gateway Series User’s Guide
28-6 Firmware and Configuration File Maintenance
Table 28-3 General Commands for GUI-based TFTP Clients
COMMAND DESCRIPTION
Host Enter the IP address of the ZyAIR. 192.168.1.1 is the ZyAIR’s default IP address when
shipped.
Send/Fetch Use “Send” to upload the file to the ZyAIR and “Fetch” to back up the file on your
computer.
Local File Enter the path and name of the firmware file (*.bin extension) or configuration file (*.rom
extension) on your computer.
Remote File This is the filename on the ZyAIR. The filename for the firmware is “ras” and for the
configuration file, is “rom-0”.
Binary Transfer the file in binary mode.
Abort Stop transfer of the file.
Refer to section 28.2.5 to read about configurations that disallow TFTP and FTP over WAN.
28.2.9 Backup Via Console Port (only for ZyAIR B-2000)
Back up configuration via console port by following the HyperTerminal procedure shown next. Procedures
using other serial communications programs should be similar.
Step 1. Display menu 24.5 and enter “y” at the following screen.
Figure 28-3 System Maintenance : Backup Configuration
Step 2. The following screen indicates that the Xmodem download has started.
Figure 28-4 System Maintenance : Starting Xmodem Download Screen
Ready to backup Configuration via Xmodem.
Do you want to continue (y/n):
You can enter ctrl-x to terminate operation any time.
Starting XMODEM download...