Filter
Top Products
ZyAIR Wireless Gateway Series User’s Guide
O-4 Log Descriptions
Chart O-5 Sys log
LOG MESSAGE DESCRIPTION
Mon dd hr:mm:ss hostname
src="<srcIP:srcPort>"
dst="<dstIP:dstPort>"
msg="<msg>" note="<note>"
This message is sent by the "RAS" when this syslog is
generated. The messages and notes are defined in this
appendix’s other charts.
Log Commands
Go to the command interpreter interface (the Command Interpreter Appendix explains how to access and
use the commands).
Configuring What You Want the ZyAIR to Log
Use the sys logs load command to load the log setting buffer that allows you to configure which logs
the ZyAIR is to record.
Use sys logs category followed by a log category and a parameter to decide what to record.
Chart O-6 Log Categories and Available Settings
LOG CATEGORIES AVAILABLE PARAMETERS
error 0, 1, 2, 3
mten 0, 1
upnp 0, 1
8021x 0, 1
urlforward 0, 1
urlblocked 0, 1, 2, 3
javablocked 0, 1, 2, 3
Use 0 to not record logs for that category, 1 to record only logs for that category, 2 to record only
alerts for that category, and
3 to record both logs and alerts for that category.
Use the sys logs save command to store the settings in the ZyAIR (you must do this in order to
record logs).