Filter
Top Products
ZyWALL 5/35/70 Series User’s Guide
Chapter 24 Policy Route 396
Packet Length Type a length of packet (in bytes). The operators in the Len Compare field apply to
incoming packets of this length.
Length
Comparison
Choose from Equal, Not Equal, Less, Greater, Less or Equal or Greater or
Equal.
Source
Interface Use the check box to select LAN, DMZ, WAN_1, WAN_2 and/or WLAN.
Starting IP
Address
Enter the source starting IP address.
Ending IP
Address
Enter the source ending IP address.
Starting Port Enter the source starting port number. This field is applicable only when you select
TCP or UDP in the IP Protocol field.
Ending Port Enter the source ending port number. This field is applicable only when you select
TCP or UDP in the IP Protocol field.
Destination
Starting IP
Address
Enter the destination starting IP address.
Ending IP
Address
Enter the destination ending IP address.
Starting Port Enter the destination starting port number. This field is applicable only when you
select TCP or UDP in the IP Protocol field.
Ending Port Enter the destination ending port number. This field is applicable only when you
select TCP or UDP in the IP Protocol field.
Action Applies to Specifies whether action should be taken on criteria Matched or Not Matched.
Routing Action
Gateway Select User-Defined and enter the IP address of the gateway if you want to specify
the IP address of the gateway. The gateway is an immediate neighbor of your
ZyWALL that will forward the packet to the destination. The gateway must be a
router on the same segment as your ZyWALL's LAN or WAN port.
Select WAN Interface to have the ZyWALL send traffic that matches the policy
route through a specific WAN port. Select the WAN port from the drop-down list
box.
Select the Use another interface when the specified WAN interface is not
available. check box to have the ZyWALL send traffic that matches the policy route
through the other WAN interface if it cannot send the traffic through the WAN
interface you selected. This option is only available when you select WAN
Interface.
Converted Type
of Service
Set the new TOS value of the outgoing packet. Prioritize incoming network traffic by
choosing Don’t Change, Normal, Min Delay, Max Thruput, Max Reliable or Min
Cost.
Converted
Precedence
Set the new outgoing packet precedence value. Values are 0 to 7 or Don’t
Change.
Log Select Yes from the drop-down list box to make an entry in the system log when a
policy is executed.
Apply Click Apply to save your changes back to the ZyWALL.
Cancel Click Cancel to exit this screen without saving.
Table 135 Edit IP Policy Route (continued)
LABEL DESCRIPTION