Filter
Top Products
ZyWALL 5/35/70 Series User’s Guide
449 Chapter 27 Remote Management
If you allow your ZyWALL to be managed by the Vantage CNM server, then you should not
do any configurations directly to the ZyWALL (using either the web configurator, SMT
menus or commands) without notifying the Vantage CNM administrator.
27.17 Configuring CNM
Vantage CNM is disabled on the device by default. Click ADVANCED, REMOTE MGMT
in the navigation panel and then click the CNM tab to configure your device’s Vantage CNM
settings.
Figure 229 CNM
The following table describes the labels in this screen.
Table 160 CNM
LABEL DESCRIPTION
Registration
Information
Registration Status This read only field displays Not Registered when Enable is not selected.
It displays Registering when the ZyWALL first connects with the Vantage
CNM server and then Registered after it has been successfully registered
with the Vantage CNM server. It will continue to display Registering until it
successfully registers with the Vantage CNM server. It will not be able to
register with the Vantage CNM server if:
• The Vantage CNM server is down.
• The Vantage CNM server IP address is incorrect.
• The Vantage CNM server is behind a NAT router or firewall that does not
forward packets through to the Vantage CNM server.
• The encryption algorithms and/or encryption keys do not match between
the ZyWALL and the Vantage CNM server.