Filter
Top Products
ZyWALL 5/35/70 Series User’s Guide
Chapter 34 WAN and Dial Backup Setup 518
Figure 278 Menu 11.3.2: Remote Node Network Layer Options
Menu 11.3.2 - Remote Node Network Layer Options
IP Address Assignment= Static
Rem IP Addr= 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= 0.0.0.0
Network Address Translation= SUA Only
NAT Lookup Set= 255
Metric= 15
Private= No
RIP Direction= None
Version= N/A
Multicast= None
Enter here to CONFIRM or ESC to CANCEL:
The following table describes the fields in this menu.
Table 195 Menu 11.3.2: Remote Node Network Layer Options
FIELD DESCRIPTION
IP Address
Assignment
If your ISP did not assign you a fixed IP address, press [SPACE BAR] and then
[ENTER] to select Dynamic, otherwise select Static and enter the IP address and
subnet mask in the following fields.
Rem IP
Address
Enter the (fixed) IP address assigned to you by your ISP (static IP address assignment
is selected in the previous field).
Rem Subnet
Mask
Enter the subnet mask associated with your static IP.
My WAN
Addr
Leave the field set to 0.0.0.0 to have the ISP or other remote router dynamically
(automatically) assign your WAN IP address if you do not know it. Enter your WAN IP
address here if you know it (static).
This is the address assigned to your local ZyWALL, not the remote router.
Network
Address
Translation
Network Address Translation (NAT) allows the translation of an Internet protocol
address used within one network (for example a private IP address used in a local
network) to a different IP address known within another network (for example a public IP
address used on the Internet).
Press [SPACE BAR] and then [ENTER] to select either Full Feature, None or SUA
Only.
Choose None to disable NAT.
Choose SUA Only if you have a single public IP address. SUA (Single User Account) is
a subset of NAT that supports two types of mapping: Many-to-One and Server.
Choose Full Feature if you have multiple public IP addresses. Full Feature mapping
types include: One-to-One, Many-to-One (SUA/PAT), Many-to-Many Overload,
Many- One-to-One and Server. When you select Full Feature you must configure at
least one address mapping set.
See Chapter 22 on page 370 for a full discussion on this feature.