64 5 - Configuring and managing the printer ENWW
To connect the printer before the installing software
If you connected the printer to the computer before installing the printer software, the Found
New Hardware wizard appeared on the computer screen.
Note If you have turned on the printer, do not turn off the printer or unplug the cable from the printer
while the installation program is running. If you do so, the installation program will not finish.
1 In the Found New Hardware dialog box that provides the option for selecting a method to
locate the driver, select the advanced option and click Next.
Note Do not allow the Found New Hardware wizard to perform an automatic search for the driver.
2 Select the check box for specifying the driver location, and ensure that the other check
boxes are clear.
3 Insert the Starter CD into the CD-ROM drive.
If the CD menu appears, close the CD menu.
4 Browse to locate the root directory on the Starter CD (for example, D), and then click OK.
5 Click Next, and then follow the instructions on the screen.
6 Click Finish to close the Found New Hardware wizard.
The wizard automatically starts the installation program (this might take a short while).
For Windows 98 and Windows Me, you must complete the installation program at this
point if you wish to install a non-English driver.
7 Complete the installation process.
Note The setup program provides options to install non-driver components such as the Toolbox,
which you are recommended to install. For instructions about installing these components,
follow the steps outlined in To install the software before connecting the printer
(recommended).
You can also share the printer with other computers using a simple form of networking known
as locally shared networking. See To share the printer on a locally shared network.
