ENWW 67
Wireless connection
If your printer supports wireless communication, you can connect the printer to a computer or
a network without cables.
Note To use wireless communication, make sure that the printer is not connected to the network
using a network cable.
For more information about setting up and configuring wireless communication and security
options, see Configuring wireless communication options.
Installing printer software and sharing the printer
Before installing the printer software, complete the following tasks:
z Obtain your network’s network name (SSID) and communication mode (infrastructure or
ad hoc) from the configuration utility for the network’s wireless access point (WAP) or the
computer’s network card. See Configuring basic wireless communication settings.
z Find out the type of security your network uses (such as WPA or WEP), and then configure
these settings in the EWS. See Configuring wireless security settings.
After you complete these tasks, follow the onscreen instructions to install the printer software
for your communication mode (infrastructure or ad hoc).
To set wireless network settings in an infrastructure network
(recommended)
1 Set up the printer hardware (see the setup poster and the getting started guide).
2 Connect the printer to the computer with the cross cable (included with the printer).
-Or-
Connect the printer to the network with a network cable.
3 Close any programs that are open on your computer.
4 Insert the Starter CD into the CD-ROM drive. The CD menu starts automatically.
If the CD menu does not start automatically, click Start, and then click Run. Browse to the
CD-ROM drive for the computer, click Autorun.exe, and then click Open. In the Run
dialog box, click OK.
5 Click Install Printer Driver and follow the instructions on the screen to complete the
installation.
6 When prompted, disconnect the cable.
To share the printer with other computers
You must install the printer software on each computer that will use the printer. The cable is
only needed when installing the printer software and configuring its wireless settings during
the first installation on the network. The cable is not required for installing the printer on other
computers on the network.
