Statement 2:
CAUTION:
When replacing the lithium battery, use only an equivalent type battery
recommended by the manufacturer. If your system has a module containing a
lithium battery, replace it only with the same module type made by the same
manufacturer. The battery contains lithium and can explode if not properly
used, handled, or disposed of.
Do not:
v Throw or immerse into water
v Heat to more than 100°C (212°F)
v Repair or disassemble
Dispose
of the battery as required by local ordinances or regulations.
To install the replacement system-board battery, complete the following steps:
1. Follow any special handling and installation instructions that come with the
replacement battery.
2. Insert the new battery:
a. Tilt the battery so that you can insert it into the socket on the side opposite
the battery clip.
b. Press the battery down into the socket until it clicks into place. Make sure
that the battery clip holds the battery securely.
3. Install the cover (see “Removing and replacing the cover” on page 43).
4. Slide the server into the rack.
5. Reconnect the external cables; then, reconnect the power cords and turn on the
peripheral devices and the server.
6. Start the UEFI Setup Utility program and reset the configuration.
v Set the system date and time.
v Set the power-on password.
v Reconfigure the server.
See
“Using the Setup Utility” on page 116 for details.
Removing and installing the PCI riser-card assembly
To remove and install the PCI riser-card assembly, complete the steps in this
section.
Chapter 5. Installing optional devices and replacing customer replaceable units 85
