7. Replace the cover
8. Slide the server into the rack.
9. Reconnect the power cord and any cables that you removed.
10. Turn on the peripheral devices and the server.
Removing and installing the virtual media key
To remove and install the virtual media key, complete the steps in this section.
Removing the virtual media key
To remove the virtual media key, complete the following steps:
1. Read the safety information in “Safety” on page vii and “Installation guidelines”
on page 39.
2. Turn off the server and peripheral devices and disconnect all power cords.
3. Remove the cover (see “Removing and replacing the cover” on page 43).
4. Grasp the virtual media key and gently slide it up and off of the mounting tab.
1 Virtual media key (front)
2 Mounting bracket (rear)
3 Mounting tab
4 Virtual media key connector
5. If you are instructed to return the virtual media key, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to
you.
Installing the virtual media key
To install the virtual media key, complete the following steps:
100 ThinkServer RD210 Types 3795, 3796, 3818, and 3819: Installation and User Guide
