1 Cover 10 2.5 inch hot-swap hard disk drive filler
panel
2 DIMM air baffle 11 SAS/SATA backplane
3 Slot 2, PCI riser card assembly 12 Fans
4 Slot 1, PCI riser card assembly 13 System board
5 Power supply filler 14 Retainer bracket
6 Power supply 15 Microprocessor
7 Optical drive 16 Heat sink
8 Operator information panel 17 Microprocessor 2 air baffle
9 2.5 inch hard disk drive
Removing and replacing the cover
Important: Before you install optional hardware, make sure that the server is
working correctly. Start the server, and make sure that the operating system starts,
if an operating system is installed, or that a 19990305 error code is displayed,
indicating that an operating system was not found but the server is otherwise
working correctly. If the server is not working correctly, see the Hardware
Maintenance Manual for diagnostic information.
Removing the cover
To remove the server cover, complete the following steps:
1. Read the safety information in “Safety” on page vii and “Installation guidelines”
on page 39.
2. Turn off the server and peripheral devices and disconnect the power cords and
all external cables, if necessary.
Note: When you disconnect the power source from the server, you will lose the
ability to view the LEDs because the LEDs will not be lit with the power source
removed. Before disconnecting the power source, make a note of which LEDs
are lit, including the LEDs that are lit on the operation information panel, the
EasyLED panel, and LEDs that are lit inside the server on the system board;
then, see the Hardware Maintenance Manual for information on how to solve
the problem.
1 Cover
2 Tab
3 Tab
Chapter 5. Installing optional devices and replacing customer replaceable units 43
