3. Reinstall the screws on the video connector 3.
4. Reinstall the hard disk drives and drive bay filler panels into the drive bays.
5. Install the cover (see “Removing and replacing the cover” on page 43).
6. Reconnect the power cords and any cables that you removed.
7. Slide the server into the rack.
8. Turn on the peripheral devices and the server.
Removing and installing the operator information panel assembly
To remove and install the operator information panel, complete the steps in this
section.
Removing the operator information panel assembly
To remove the operator information panel, complete the following steps.
1. Read the safety information in “Safety” on page vii and “Installation guidelines”
on page 39.
2. Turn off the server and peripheral devices and disconnect all power cords.
3. Remove the cover (see “Removing and replacing the cover” on page 43).
4. Disconnect the cable from the back of the operator information panel 1
assembly.
5. Use an object to push down on the release tab; hold down the release tab 2
and push the blue push point on the rear of the panel to the front of the server.
Chapter 5. Installing optional devices and replacing customer replaceable units 109
