1 Adapter
2 Expansion slot cover
3 PCI riser card assembly
5. Install the riser-card assembly in the server (see “Removing and installing a PCI
riser-card assembly” on page 53).
6. Perform any configuration tasks that are required for the adapter.
If you have other options to install or remove, do so now. Otherwise, go to
“Completing the installation” on page 111.
Removing and installing a memory module (DIMMs)
To remove and install a memory module, complete the steps in this section.
Removing a memory module (DIMMs)
To remove a dual inline memory module (DIMM), complete the following steps:
1. Read the safety information in “Safety” on page vii and “Installation guidelines”
on page 39.
2. Turn off the server and peripheral devices and disconnect all power cords.
3. Remove the cover (see “Removing and replacing the cover” on page 43).
4. Disconnect any cables that impede access to the DIMMs.
5. Remove the DIMM air baffle (see “Removing and installing the DIMM air baffle”
on page 48).
6. Carefully open the retaining clips 2 on each end of the DIMM connector and
remove the DIMM 1.
Attention: To avoid breaking the retaining clips or damaging the DIMM
connectors, open and close the clips gently.
7. If you are instructed to return the DIMM, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Installing a memory module (DIMMs)
The following notes describe the types of DIMMs that the server supports and other
information that you must consider when you install DIMMs :
58 ThinkServer RD210 Types 3795, 3796, 3818, and 3819: Installation and User Guide
