A SERVICE OF

logo

1 UEFI boot recovery jumper (J29)
2 IMM recovery jumper (J147)
3 SW4 switch block (reserved)
4 SW3 switch block
Attention: Before you change any switch settings or move any jumpers, turn off
the server; then, disconnect all power cords and external cables. See the safety
information in “Safety” on page vii and “Installation guidelines” on page 39. Do not
change settings or move jumpers on any system-board switch or jumper block that
is not shown in this document.
Administrator password
If an administrator password is set, you must type the administrator password for
access to the full Setup utility menu. You can use any combination of up to seven
characters (A - Z, a - z, and 0 - 9) for the password.
Chapter 6. Configuring the server 121